October 14, 2024, 08:00:40 AM

MOD-RFID1356MIFARE single read mode

Started by Georg Viertbauer, November 08, 2016, 12:13:09 PM

Previous topic - Next topic

Georg Viertbauer

Hello
I've connected the board over USB CDC.
All works fine ... also setting up the trigger frequency.
Is there a way to set up the scan to single read mode?
The msXX command of the MOD-RFID1356 would be nice.

kr Georg Viertbauer


LubOlimex

Hey,

At the moment there is no single read command similar to the msXX one from MOD-RFID1356. There is only mtF command that sets the scan interval.

Thanks for the input, though. The maintainer of the firmware has been notified about this requested feature.

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex