Welcome, Guest

Author Topic: MOD-RFID1356MIFARE single read mode  (Read 1590 times)

Georg Viertbauer

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
MOD-RFID1356MIFARE single read mode
« on: November 08, 2016, 12:13:09 PM »
Hello
I've connected the board over USB CDC.
All works fine ... also setting up the trigger frequency.
Is there a way to set up the scan to single read mode?
The msXX command of the MOD-RFID1356 would be nice.

kr Georg Viertbauer

Georg Viertbauer

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: MOD-RFID1356MIFARE single read mode
« Reply #1 on: December 07, 2016, 11:32:00 AM »
 :( hmmm no replies  :(

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1819
  • Karma: +46/-2
Re: MOD-RFID1356MIFARE single read mode
« Reply #2 on: December 08, 2016, 09:15:32 AM »
Hey,

At the moment there is no single read command similar to the msXX one from MOD-RFID1356. There is only mtF command that sets the scan interval.

Thanks for the input, though. The maintainer of the firmware has been notified about this requested feature.

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex

Georg Viertbauer

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: MOD-RFID1356MIFARE single read mode
« Reply #3 on: December 14, 2016, 10:34:36 AM »
Thx a lot