Welcome, Guest

Author Topic: MSP430-HFR5739 User Manual  (Read 1514 times)

KlaRa

  • Newbie
  • *
  • Posts: 11
  • Karma: +0/-0
MSP430-HFR5739 User Manual
« on: August 25, 2016, 01:53:06 PM »
Hello,
I bought two boards of the type MSP430 HFR5739 currently. I miss the User Manual. It would be nice also a demo software, as usual.
On the boards is something uploaded. With key 1 a LED lights, pushbutton 2 blinks the second LED and stop after a short time again.
Currently get transferred to the JTAG-Tiny-V2 and the CCS6 no code. With the IAR 6.4 this goes at least, but I get no LED to illuminate.

Please help, Klaus.

LubOlimex

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1713
  • Karma: +43/-2
Re: MSP430-HFR5739 User Manual
« Reply #1 on: August 29, 2016, 02:30:34 PM »
Hey,

Thanks for the notice! Now there is a demo for the board here: https://www.olimex.com/Products/MSP430/Header/MSP430-HFR5739/resources/MSP430-HFR5739_demo.zip

Best regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex

KlaRa

  • Newbie
  • *
  • Posts: 11
  • Karma: +0/-0
Re: MSP430-HFR5739 User Manual
« Reply #2 on: September 03, 2016, 07:53:07 PM »
Thanks for the Source.

But my real problem is, my MSP430-JTAG-TINY-V2 can not write to the internal memory of the MSP430-HFR5739. I had purchased a board with CC430F5137 a few months ago. This has no problem with the environment. I have tested it currently again, no problem with the CC430F5137.

The demonstration program of OLIMEX for the MSP430-HFR5739 ran. Then I tried myself to load a simple blinking LED. With my second board happened exactly the same.

IAR 6.4
Could not write device memory : (WriteMemory) , address=0xc200, buffer=1@, count=0xa0
Trying to initialize target failed

Greetings Klaus

« Last Edit: September 03, 2016, 08:15:30 PM by KlaRa »