October 02, 2023, 03:21:43 PM

MOD-RFID1356MIFARE single read mode

Started by Georg Viertbauer, November 08, 2016, 12:13:09 PM

Previous topic - Next topic

Georg Viertbauer

I've connected the board over USB CDC.
All works fine ... also setting up the trigger frequency.
Is there a way to set up the scan to single read mode?
The msXX command of the MOD-RFID1356 would be nice.

kr Georg Viertbauer



At the moment there is no single read command similar to the msXX one from MOD-RFID1356. There is only mtF command that sets the scan interval.

Thanks for the input, though. The maintainer of the firmware has been notified about this requested feature.

Best regards,
Technical support and documentation manager at Olimex