Started by jwischka, December 17, 2012, 06:36:15 AM
QuoteOct 23 15:40:46 ubuntu wpa_supplicant: wlan3: CTRL-EVENT-DISCONNECTED bssid=00:8e:f2:b9:87:2e reason=0Oct 23 15:40:53 ubuntu wpa_supplicant: wlan3: Trying to associate with 00:8e:f2:b9:87:2e (SSID='slycommedia' freq=2437 MHz)Oct 23 15:40:53 ubuntu wpa_supplicant: wlan3: Association request to the driver failedOct 23 15:40:53 ubuntu wpa_supplicant: wlan3: Associated with 00:8e:f2:b9:87:2eOct 23 15:40:54 ubuntu wpa_supplicant: wlan3: WPA: Key negotiation completed with 00:8e:f2:b9:87:2e [PTK=CCMP GTK=CCMP]Oct 23 15:40:54 ubuntu wpa_supplicant: wlan3: CTRL-EVENT-CONNECTED - Connection to 00:8e:f2:b9:87:2e completed (reauth) [id=0 id_str=]
Quote from: SlyCom on October 25, 2013, 01:48:03 AMjwischka,Is the ipv6 support enabled/disabled in R18 or in R19?
Quote from: SlyCom on October 25, 2013, 05:40:37 PMYes, please. Is it possible to disable the ipv6 support? or it must be done in kernel?
Quote from: SlyCom on October 25, 2013, 06:09:55 PMIf your read my previous post. I have a problem with drop connection, slow connection in R18 and R19 I thought that it can be problem with ipv6. I still don't know if this is a problem but I'm trying to find it out.Another question. Is it possible to enable board watchdog? Sometimes my board just hangs and I can reset it manually. To enable the watchdog do I need recompile the kernel or maybe there is simplest solution?
Quote from: SlyCom on October 25, 2013, 06:41:44 PMI installed fresh R19 beta image set the wlan, tried use wget method and the speed is decreasing and stops after few seconds. Very often the board hangs (or drop the connection). Currently I uploaded fresh R18 image and my java application works (over 3 hours now). I have no idea where is the problem.In my application I use connection to get information from server every 2 seconds but it's not huge amount of data (approx. 50 bytes). I don't think that it's related to my application as the fresh image also drop the connection (sometimes). I have two boards running close to each other maybe there is some kind of interference? I need more investigation but good information is that only I have similar problem.So, the power safe mode is off in image R18?P.S.Some time ago you released image R19 beta. There is support for ttl converters based on Cx2103. How I can add support for Cx2103 in R18?