Welcome, Guest

Author Topic: OTG power connectors  (Read 1949 times)

zabravanko

  • Newbie
  • *
  • Posts: 6
  • Karma: +0/-0
OTG power connectors
« on: May 25, 2016, 07:29:40 PM »
Hello guys,
maybe I have a problem with my PIC32-PINGUINO-OTG. It is about its power connectors - there are +5V and +3.3V pins on power con1. I have never used them for supplying aims. Everything with programming the pic32 with pic-kit3 are ok, but when I try to measure the voltage on these pins, I have these results:
- between pins 5V and GND - measured 0V
- between pins 3.3V and GND - measured 2.9V
Actually I am planning to supply a sensor circuit with this 5V pin, but the voltage is missing.. I know how to work and measure with multimeter.
Any suggestions :) ?
« Last Edit: May 25, 2016, 07:32:39 PM by zabravanko »

zabravanko

  • Newbie
  • *
  • Posts: 6
  • Karma: +0/-0
Re: OTG power connectors
« Reply #1 on: May 26, 2016, 12:42:06 PM »
Hello again,
I have observed the schematic of the board and .. It was my fault.. When I power up the board thru USB connector, these voltages are ok.