March 19, 2024, 11:35:17 AM

libary's

Started by Ben, December 17, 2014, 12:50:18 PM

Previous topic - Next topic

Ben

Dear forum users
I have 3 little questions.
1) how do i get the libmaple files to work? I can't find a clear explanation on how to do it.(I'm using a windows pc)
2) Is there a good tutorial on writing library's that are maple ide compatible?
3) are the input pin on a OLIMEXINO-STM32 board 5V tolerant?
Best regards Ben

JohnS

#1
Can't help on the 1st two but for the last what I do is grab the chip datasheet and check it.  You'll need it to understand the chip, anyway.

With some chips only some pins are 5FT.  Some, none are.  Often, analog pins are not 5FT.

Sometimes the chip or board makers mark the schematic.

John