Welcome, Guest

Author Topic: A10 Lime shield  (Read 1809 times)

electrolab

  • Newbie
  • *
  • Posts: 6
  • Karma: +0/-0
A10 Lime shield
« on: July 22, 2014, 11:35:17 AM »
Hello guys
I am doing a shield for the olinuxino A10 lime and i am wondering about the connectors to hook in the idc pin male header.
Here is the connector am planning to use:
http://www.digikey.com/product-detail/en/M52-5112045/M52-5112045-ND/3922744
My calculations say that i wont have enough space.
I am not sure if there is a way to make a shield that wont touch the rj45 and the hdmi connectors.
Has anyone made a sfield with a good connector so that the shield don't touch the RJ45 and hdmi connectors of the olinuxino?
Regards

electrolab

  • Newbie
  • *
  • Posts: 6
  • Karma: +0/-0
Re: A10 Lime shield
« Reply #1 on: July 23, 2014, 09:12:55 PM »
I guess i am the only one who wants to make a shield for the olinuxino lime. I have to go back to the ribbon cable then.

jaap

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Re: A10 Lime shield
« Reply #2 on: August 20, 2014, 11:48:26 PM »
Me! Me! A simple GPIO breakout board would be nice, for a start!