A10 Lime shield

Started by electrolab, July 22, 2014, 11:35:17 am

Previous topic - Next topic


Hello guys
I am doing a shield for the olinuxino A10 lime and i am wondering about the connectors to hook in the idc pin male header.
Here is the connector am planning to use:
My calculations say that i wont have enough space.
I am not sure if there is a way to make a shield that wont touch the rj45 and the hdmi connectors.
Has anyone made a sfield with a good connector so that the shield don't touch the RJ45 and hdmi connectors of the olinuxino?


I guess i am the only one who wants to make a shield for the olinuxino lime. I have to go back to the ribbon cable then.


Me! Me! A simple GPIO breakout board would be nice, for a start!