HDMI to DVI output

Started by michal.siman, March 10, 2014, 07:47:59 pm

Previous topic - Next topic

michal.siman

I would like use standart computer monitor (4:3) with resolution 1024x768 or 1280x1024 with HDMItoDVI cable. It is working, not correct ratio. How i can setup it? Thank you.

lubod

For the disk image supplied by Olimex:

https://www.olimex.com/wiki/A10-OLinuXino-LIME#How_to_change_HDMI.2C_VGA_and_LCD_resolutions.3F

If you 'roll your own' I think you'd have to reconfigure elsewhere, maybe uImage or script.bin on the boot partition. I think I read some references how to do it, but didn't bookmark them and can't find them in my browser history. I'll edit this post to add them if I find it again soon.

michal.siman

Yes, thank you, but this i know.

My question again: how i can setup my own resolution on HDMI output.

Now, i tried setup VGA by script, but this action route output to VGA connector (GPIO) and HDMI output is death. I need only change resolution on HDMI output!

michal.siman

BTW: Where is VGA output? I cannot found it in any manual for A10 ...

JohnS


michal.siman

Quote from: JohnS on March 12, 2014, 10:28:31 pm
See reply #1

John


ok, "custom 6 pin connector" - but where is it? on picture is nothing like "custom" and nothing like "6 pin" :-(

JohnS

The idea is that sometimes you put a bit of effort in.

John