November 01, 2024, 02:08:55 AM

MOD-RFID125 Firmware

Started by George7069, June 23, 2014, 12:42:19 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

George7069

June 23, 2014, 12:42:19 AM
Hi,
I have just purchased several of these units and think they are great - but is there a way to inhibit the extra data bytes that are added to a token read? ie the line feed and CR characters that seem to be applied to the end of a message. There are also a couple in front.

George

George7069

#1
June 24, 2014, 01:03:57 AM
Further to my previous, does anyone have a copy of the Mod-Rfid firmware inc source code if possible for me to have a look at and see if I can mod it.

Thanks in advance.

George

George7069

#2
June 30, 2014, 02:04:32 AM
As an aside there is a connector strip inside the MOD-RFID125, does anyone know the pin outs of them?

Thanks in advance

CHulla

#3
September 09, 2014, 01:38:08 PM
Quote from: George7069 on June 30, 2014, 02:04:32 AM
As an aside there is a connector strip inside the MOD-RFID125, does anyone know the pin outs of them?

Thanks in advance

The 6pin connector is ICSP (In circuit serial programmer)connector. The sequence of the pin is given on PCB i.e 1 to 6. You need ICSP connector when you want to program the firmware to Controller(AT90USB162).
www.olimex.com/Products/Modules/PIC-ICSP-Connector/
Print
Go Up Pages1
User actions