MOD-WIFI-ESP8266-DEV out of the box

[soloflight]

Hello all,

I've just received my MOD-WIFI-ESP8266-DEV boards and plug it on my breadboard.
connected pins are, GND, 3.3, and RX/TX. the MOD-WIFI-ESP8266-DEV is in default flash mode.

when i connect to it at 115200 i have a welcome "ready" than when passing AT i receive OK.

But any other command like AT+CMGR or AT+CWLAP are returning ERROR.

any setup i missed...

regards

[JohnS]

Try other AT commands.

You may need both CR and LF.

John

[soloflight]

sorry everybody...

the module comes by default in mode 3 (ie AP) , so AT+CWLAP wich is a scanning command is not available

i switched to mode 1 by AT+CWMODE=1 and everything is working fine

[JohnS]

If only all the posts were so quickly resolved

Good to hear!

John