I've download u-boot source from https://github.com/OLIMEX/u-boot-olinuxino
and make config make
make CROSS_COMPILE=aarch64-linux-gnu- BL31=../atf/bin/bl31.bin a64-olinuxino_defconfig
and make menuconfig and set
CONFIG_TARGET_A64_OLINUXINO=y
CONFIG_LAST_STAGE_INIT=y
and build is OK.. but build version filesize(738kB) is smaller than download version(868kB)
and when I type 'saveenv' in u-boot command. error is displayed like below
Saving Environment to EXT4... File System is consistent
mmc write failed
** fs_devread read error - block
** fs_devread read error - block
Error in getting the block group descriptor table
fs_devread read outside partition 16907251040
** fs_devread read error - block
** fs_devread read error - block
error in File System init
** Unable to write "/uboot.env" from mmc0:1 **
Failed (1)
Can you send me .config file of A64 board?
eschoi@huvitz.com
All sources are shared at the GitHub.
Make sure to follow the description on how to build the image at the bottom of this document:
https://github.com/OLIMEX/OLINUXINO/blob/master/DOCUMENTS/OLIMAGE/Olimage-guide.pdf