Hi,
so far everything work fine with the adapter and openOCD.
But I have a custom board which start up in SWD mode. I cannot change the bootstrapping of the PCB.
I thought it should be easy to switch back to normal JTAG mode, i.e to apply the ARM-SWD2JTAG sequence.
However, I cannot control the TMS, TCK signal with
ftdi_set_signal TMS,...
I guess that it is related that it is not defined in the FTDI layout section.
Is it allowed to add the TMS in the config file ? Or do I mess something up with the MPSS?
May be there is a more simple method to send custom pattern ?
I did not find any reference.
thx
Try asking on the OpenOCD ML :)
John
Have you considered using the SWD adapter for the debugger, then you can operate directly in SWD mode:
https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-SWD/