Hello everyone,
Does anyone know how to wire the Olimex ENC28J60 ethernet adapter to the imx233 processor?
ENC28J60
Pin#
1 SCK 6 CLKOUT
2 MOSI 7 CS
3 MISO 8 RST
4 WOL 9 GND
5 INT 10 3.3V
Have you seen this project: https://github.com/mkschreder/hack-enc28j60-imx233
great project, but the picture on the project, i could not make out which pin goes to which. Anyone have any idea?
I'd figure power & gnd, then the signalling pins from the datasheet - bear in mind it'll just not work if you get these ones wrong but will do no damage so long as you got power & gnd right.