Print Page - Is my Olinuxino A10 S dead?

Title: Is my Olinuxino A10 S dead?
Post by: MANU62170 on September 28, 2017, 02:11:07 PM

Hello!

My Olinuxino A10S doesn't start anymore. Even the little light does'nt appear.

I tested the external power supply, it is OK.

Is it possible that juste the internal power entry is out of order and can it be replaced? Please send me the link where I have to g@ to, to buy it.

I am quite ecologist, and I' rather I would repair my Olinuxino A 10S than throwing it away.

Thanks a lot for your answer :-)

Title: Re: Is my Olinuxino A10 S dead?
Post by: benstmax on September 28, 2017, 05:09:32 PM

You should check the power rails provided by the AXP152 chip. If these are not ok, the PWR led won't light.
Open the schematic https://github.com/OLIMEX/OLINUXINO/tree/master/HARDWARE/A10S-OLinuXino-MICRO (https://github.com/OLIMEX/OLINUXINO/tree/master/HARDWARE/A10S-OLinuXino-MICRO) for your particular board revision.

Title: Re: Is my Olinuxino A10 S dead?
Post by: MANU62170 on September 28, 2017, 10:25:49 PM

Thanks for your answer, benstmax, but I can't find what you say. Can you send me exactly the link to the file I must go to, to open the shematic of the Olinuxino A10 S, or send me the picture ?

Thanks :-)

Title: Re: Is my Olinuxino A10 S dead?
Post by: benstmax on September 29, 2017, 01:03:00 PM

Which board revision do you have? All my A10s boards are Rev.C

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A10s => Topic started by: MANU62170 on September 28, 2017, 02:11:07 PM