I download openwrt chaos calmer an using make menuconfig I create an image for imx233 but when I copy to SD card
The board load u-boot and the process end
I want a know how can I create an SD image with u-boot and openwrt starting files
Thanks for any advice on this issue
Sergio Sosa
I download openwrt 15.05 branch (Chaos Calmer) using
git clone -b chaos_calmer git://github.com/openwrt/openwrt.git
run make menuconfig to configure it to target system "Freescale i.mx23/i.mx28" and target profile "Olimex Olinuxino maxi/mini boards"
run make V=s
and I obtain in the following dir ...bin/ mxs the next file
openwrt-mxs-olinuxino-maxi-sdcard-vfat-ext4.img
and using windows win32diskimager I copy to SD card
I load my custom board but my output is
U-Boot 2015.01 (May 03 2017 - 20:41:15)
CPU: Freescale i.MX23 rev1.4 at 454 MHz
BOOT: SSP SD/MMC #0
DRAM: 64 MiB
MMC: MXS MMC: 0
*** Warning - bad CRCCOMMA using default environment
In: serial
Out: serial
Err: serial
Net: Net Initialization Skipped
No ethernet found.
Hit any key to stop autoboot: 3 '8''8''8' 0 ('8' es un backspace)
=>
I not have keyboard to write something
I see in https://wiki.openwrt.org/toh/olimex/imx233-olinuxino the next comment
Further notes
The board uses a special boot image called bootstream / safeboot. The file includes a zImage, a compiled devicetree, and various preparation bootlets (power_, sdram_, linux_)- these are contained in package/imx-bootlets. The image is created by the elftosb tool.
My question is
How can i copy the correct files to SD card and with what tool
Thanks for your help
Sergio Sosa
Since your system is successfully starting u-boot, your SD card seems to fine, actually.
You do not need a key board: The same serial connection, that provides the output, that you are showing, also can be used for input...