Hello
I Purchaesd the debugger from olimex for my project, which is stopped for the production due to CC2640 MCU+BLE is not able to detected.
while trying to flash CC2640 target board using a XDS110 v3 rec C Debugger using SmartRF Flash Programmer 2 (v1.7.2) , but in the connected pair columm UNKNOW is coming .then we tried with "CC26xx/CC13xx Forced mass erase" but FAILED operation is coming.
In debugger , 20 pin ARM connector is being used by placing 20 to 10 pin conveter and then 10 to 6 pin converter as target board has 6 pin of nails to flash.
I tried the same setup to flash the CC2640 with 20 pin of Smart RF evaluaton board 06 , It works. From this it could be concluded that some issue is from debugger board side .
Kindly suggest the following points :
share the schematic of XDS110 v3 rec C .
suggest how to flash board with debugger.??
At the Pin 1 of debugger 1.6 V is coming , which should be 3,3 as Vref as mentioned in datasheet .
PLZ reply soon
Reference links
www.ti.com/.../TMDSEMU100v2U-ARM
www.tag-connect.com/.../TC2030-CTX.pdf ? (10 to 6 pin converter cable)
www.embeddedartists.com/.../acc_jtag_adapter_kit.php (10 to 6 pin conveter)
Thanks in advance
Hey,
Are you using the proper connector? I used the ARM_JTAG connector and had the ARM_JTAG_E jumper closed. J4 and J5 jumpers were open.
Did you modify device_info.xml as suggested in the FAQ section at the bottom of the product page: https://www.olimex.com/Products/DSP/Emulators/TMS320-XDS100-V3/ ?
I've personally tested CC2650 and XDS100-V3 and they work fine.
Best regards,
Lub/OLIMEX