Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A10s => Topic started by: lukasik on May 12, 2015, 05:54:31 PM

Title: A10S MICRO how to connect
Post by: lukasik on May 12, 2015, 05:54:31 PM
Hello,

I'm begginer with this so this is maybe trivial but I'm stuck.

My setup:

If I connect device to pc pwr led light is on but nothing else happens, no dhcp client in router/data on tty
Hold ~8 power - goes off
Hold ~1s power - goes to the same state as before

How do I get this to work?


Title: Re: A10S MICRO how to connect
Post by: JohnS on May 25, 2015, 11:24:15 AM
With dd, what of= ?

Onedrive just says Sorry, something went wrong.  You need only GND, Tx, Rx connected at A10S.  If no output, swap Tx & Rx.

John

Title: Re: A10S MICRO how to connect
Post by: harrywest on July 07, 2023, 09:58:24 AM
Quote from: lukasik on May 12, 2015, 05:54:31 PMHello,

I'm begginer with this so this is maybe trivial but I'm stuck.

My setup:
  • A10S-OLinuXino-MICRO Rev.C
  • UART to notebook USB, see images: http://1drv.ms/1csXOva, http://1drv.ms/1RzR5A3
bloxd io (https://bloxdio2.com)
  • MicroUSB connected to notebook USB
  • LAN to router
  • SD card with A10S_debian_3_4_GPIO_LAN_USBs_SDs_HDMI_LCD_I2C_100KHz_TS_4G_release_4.img created by dd bs=4M oflag=sync if=A10S_debian_3_4_GPIO_LAN_USBs_SDs_HDMI_LCD_I2C_100KHz_TS_4G_release_4.img
  • screen /dev/ttyUSB0 115200

If I connect device to pc pwr led light is on but nothing else happens, no dhcp client in router/data on tty
Hold ~8 power - goes off
Hold ~1s power - goes to the same state as before

How do I get this to work?

Hi, why don't you check your UART connection? Verify that your UART connection is set up correctly and that you are using the correct serial port on your PC. Make sure the baud rate is set to 115200, which is the default for the A10S-OLinuXino-MICRO Rev.C board.