Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A10 => Topic started by: johnfulgor on April 22, 2015, 12:57:39 pm

Title: Powering from 0.05" connectors
Post by: johnfulgor on April 22, 2015, 12:57:39 pm
Hello all,
is it possible to use the +5 pins on the various 0.05" connectors to power the board? (I mean, not getting power from the board, but giving power to it!). What is the purpose of the D3 diode (not fitted) and what is the meaning of the electronic device that appears in parallel to this diode, with the label "5V_E OPEN"?
Thank you.
John
Title: Re: Powering from 0.05" connectors
Post by: JohnS on April 22, 2015, 01:29:07 pm
Sounds like a solder bridge / jumper but which board?

If it's like their usual boards E is enable.

John
Title: Re: Powering from 0.05" connectors
Post by: johnfulgor on April 24, 2015, 06:18:40 pm
Quote from: JohnS on April 22, 2015, 01:29:07 pm
Sounds like a solder bridge / jumper but which board?

If it's like their usual boards E is enable.

John


A10-OLinuXini-LIME. What is this bridge for?
Thank you.