I am a newbie to the whole pinguino family, so forgive my ignorance of the obvious. I am working with the Pinguino-OTG, MOD-RGB module and 32 bit Windows Vista.
I have been able to install my pinguino IDE and the drivers such that the blink example works. I know the board is working. However when I try to use the fade example found here https://www.olimex.com/Products/Modules/LED/MOD-RGB/ (https://www.olimex.com/Products/Modules/LED/MOD-RGB/), I can compile and load it with all the same successful indications, however it does not work... I have connected the MOD-RGB unit and the Pinguino boards with the UEXT cable; and I have a 120W 12V supply running a short LED string through the MOD-RGB unit, so I know there is enough power to run the lights.
I find it frustrating the lack of debugging tools. I am using the pinguino x.4 IDE and all I can find is that there is no debugging tool (for this version). Is that still accurate? I was looking for the x.3 which had CDC debugging, but I cannot find it :(
Besides the debugging, Is there something I might be missing? I have tried all permutations on the jumpers of the MOD-RGB board so I hope I haven't messed it up too bad.
Any help would be appreciated!
Thanks!
Hey pewpew,
Did you notice that MOD-RGB has different versions of firmware?
The Pinguino example (that is found at the wiki article of MOD-RGB) works out-of-the-box only with MOD-RGB with firmware version 2. It seems very likely that you own a MOD-RGB with firmware versions 3. The demo would require modifications to be able to use it. I recommend you to check the firmware 3 documentation in the respective archive.
Best regards,
Lub/OLIMEX