I was trying to initiate my AVRISP MK2 programer and it give me this error. The ultimate goal is try to program a atmega1284p (smd version)
Problem 1
AVRISP mk2 firmware upgrade failed
Firmware version On tool: 1.11 On disk 1.17
I tried to press the upgrade button then i get this message
AVRISP MkII firmware upgrade failed. toggle power on tool and retry upgrade
On atmel studio i have this setting Tool --> device programing
Tool: AVIRISP MKII Device: AT90USb162 Interface: ISP
the instruction manual didn't really say how to upgrade the firmware if iam using atmel studio, they
seem to be for arduino, AVRDUDE or linux?
------------------------------------------------------------------------------
Problem 2
When I have atmel Flip opened up I selected Device --> AT90USB162
Then I try to select Communication medium --> usb I get two error message pop up.
Message 1: AtLibUsbDfu.dll not found
Message 2: SettingMenuHandler: Could not load dynamic library.
------------------------------------------------------------------------
Guys I am super stuck. I installed all the driver provided at the olimex site for the AVRISP Mk2
Nothing seems to work.
Any advise is appreciate
Thanks Guys
Henry
I look through some of the previous post and figured out I needed to point my driver to atmel usb folder.
I am still trying to update the firmware on the device. Assuming I have the correct driver for flip. Now I am stuck exactly at section 4.2.4 of the instruction Select Settings -> Communication -> USB -> Open
Flip program gave me this error: Could not open usb device.
Is there any setting on the avr programer i need to perform. For example. Change 5v to 3.3v or target on or off?
Thanks
nevermind, stupid mistake. I had to push the upgrade button in order for flip to recognize the device.