Hello all!
I've been doing some development on imx233-olinuxino. I need to use many of the GPIO lines, mostly for output, but I'd also need 5-7 input lines.
As I have observed, certain pins don't have a pullup configuration. I made a try to enable the pullup configuration in the kernel (2.6.35.3) in imx233_olinuxino_pins.c, without effect, so if it's configured as input, the default signal level is still 0.
The pin in question is GPIO.03, which is called GPMI_CLE. Having a look at the mx23 manual, it appears to me that only a few GPIO pins have a built-in pullup resistor in the processor.
I simply can't believe it; could you please confirm or reject this? Furthermore, are there pullups on the PCB itself for certain pins?
Thanks, regards,
Tamas