Hi,
I want to use the MSP430-CCRF powered by a 1 cell Lipo battery (probably with a usb charger in between). I checked the datasheet of the MCP1702T LDO and it supports this use. So i should be fine? The MSP430-CCRF datasheets only give a allowed input voltage of 4-12VDC. This would be not enough on the low end and is also below the MCP1702T specification. Why?
I am just a little bit confused, because you mention lipo battery powered use of the MSP430-CCRFLCD, which also uses a slightly other LDO (MCP1700).
Thanks a lot!
Manuel
Hello Manuel,
It's ok to use 3.7V LiPo battery with MSP430-CCRF.
Best regards,
Lub/OLIMEX