Olimex Support Forum

ARM => ATMEL => Topic started by: prateekarora89 on August 08, 2013, 05:03:47 PM

Title: Configuring SAM7P256 with ARMUSBOCD
Post by: prateekarora89 on August 08, 2013, 05:03:47 PM
HI,


I have Recently purchased an OLIMEX SAM7P256  Board and I want to Configure it using ARM USB OCD.  I have done most of the part but I am facing problem during flash programming the device it is not able to find the script.ocd file so kindly help me out in this.

Title: Re: Configuring SAM7P256 with ARMUSBOCD
Post by: LubOlimex on September 04, 2013, 03:48:30 PM
Hello prateekarora89,

Have you tried with the free Olimex OpenODS IDE? Might be found here: https://www.olimex.com/Products/ARM/JTAG/_resources/OpenOCD/ (https://www.olimex.com/Products/ARM/JTAG/_resources/OpenOCD/).

The script needed for SAM7-P256 is typically located in openocd-0.7.0\scripts\target in the OpenOCD folder. It is named "at91sam7x256.cfg".

Best regards,
Lub/OLIMEX