Print Page - Jumpers for hardware i2c

Title: Jumpers for hardware i2c
Post by: slashdotted on October 12, 2012, 12:29:20 PM

Hello,
before doing some damage to my olinuxino maxi, I would like to ask... you how the jumpers to enable hardware i2c
are supposed to be soldered?

FYI here's an image of the board: http://imageshack.us/a/img842/732/maxir.png

Should I simply solder the center lead with the right lead for both SCL and SDA? If anybody can link a picture of the expected result it would be great.

thank you in advance

Title: Re: Jumpers for hardware i2c
Post by: LubOlimex on October 12, 2012, 03:04:06 PM

Hey there,

Check this image with explanation: http://i.imgur.com/wh41X.jpg (http://i.imgur.com/wh41X.jpg). Any guide or video you can find for setting SMD jumpers might prove useful.

Best regards,
Lub/OLIMEX

Title: Re: Jumpers for hardware i2c
Post by: slashdotted on October 12, 2012, 04:18:23 PM

thank you very much! :)

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => iMX233 => Topic started by: slashdotted on October 12, 2012, 12:29:20 PM