Print Page - Olimexino STM32 rev. E

Title: Olimexino STM32 rev. E
Post by: randy on June 17, 2013, 09:05:08 PM

Hey,

I just bought a Olimexino STM32 revision E by Antratek in the Netherlands.
I cannot find no information on your site about this revision. I also cannot use
the Maple IDE (Windows 7) to download programs in this board which has great specification.
Can you give me advise which will sure work, for instance the SWD interface with
or Jtag. Do you sell this or do I have to buy it for instance from Segger.

Randy.

Title: Re: Olimexino STM32 rev. E
Post by: LubOlimex on June 18, 2013, 04:44:03 PM

Hey randy,

Did you follow the instructions here: http://www.olimex.dev/Products/Duino/STM32/OLIMEXINO-STM32/resources/Olimexino-STM32_Installation.pdf (http://www.olimex.dev/Products/Duino/STM32/OLIMEXINO-STM32/resources/Olimexino-STM32_Installation.pdf)?

Of course the board might be used as a general purpose STM32 board. The thing is it uses the small JTAG/SWD 10-pin connector so you would probably need a small adapter cable like this one: https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10/ (https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10/). Any STM32 Cortex compatible debugger plus the linked adapter would work.

Best regards,
Lub/OLIMEX

Title: Re: Olimexino STM32 rev. E
Post by: nmap on March 19, 2014, 03:15:23 PM

Hello,

I also have Olimexino-STM32 Rev. E. I'm wondering what changes have been made to the schematic or layout since rev. D, which is the last one documented.

Thanks,
Chris

Title: Re: Olimexino STM32 rev. E
Post by: LubOlimex on April 07, 2014, 04:24:44 PM

Hello Chris,

There are only 2 minor optimizations that doesn't affect any behavior in particular:

1. R18 gets changed from 3k/1% to 3.01k/1%
2. C15(tant 47uF/6.3V) is now replaced by two capacitors 22uF/6.3V0603

Best regards,
Lub/OLIMEX

Olimex Support Forum

DUINO => MAPLE => Topic started by: randy on June 17, 2013, 09:05:08 PM