Hello,
The document ug1002 "Toolchain Installation User Guide" is listed on your website.
Inside I find:
(https://i.postimg.cc/j553F5Yw/image.png)
Following the directions, however, I find this:
https://colognechip.com/programmable-logic/gatemate/toolchain/
It seems that document ug1002 describes the legacy toolchain called cc-toolchain-linux.tar.gz,
but as you can see on the page, the most recent toolchain is oss-cad-suite-linux (https://github.com/YosysHQ/oss-cad-suite-build/releases/).
However, I cannot find any usable examples in this new toolchain.
I found some examples (perhaps) that could be useful here: https://github.com/YosysHQ/prjpeppercorn-test-cases
What do you think about using the new toolchain?
Do you have any quick guides on this? Or even just suggestions?
regards
Max
We have no experience with it. Only used the OSS CAD Suite.