Print Page - LCD-OLinuXino-4.3TS and Olimex A20

Title: LCD-OLinuXino-4.3TS and Olimex A20
Post by: gatgat on March 22, 2016, 02:51:01 PM

Hi,

I recently bought a LCD-OLinuXino-4.3TS for my A20. I write the official DEBIAN image on my sd card and plugged my lcd on LCD_CON. Booted then i used change_display to fit my resolution. But i have nothing displayed on my lcd, it doesn't even seem powered.

How can i check if my lcd is working?

thanks

Title: Re: LCD-OLinuXino-4.3TS and Olimex A20
Post by: LubOlimex on March 25, 2016, 02:32:04 PM

Hey,

Test with the previous Debian Wheezy release, instead of the latest Jessie one.

The resoltion for the 4.3 inch display is under the LCD menu - 480x272.

You might need a good power supply to power both the board and the display, do not count on powering both from the USB.

If possible test with another interface method - native HDMI monitor or a serial cable (to the debug pins) and a personal computer.

Best regards,
Lub/OLIMEX

Title: Re: LCD-OLinuXino-4.3TS and Olimex A20
Post by: oldpenguin on April 07, 2016, 08:05:26 PM

Hello

I am running Debian Jessie, kernel 3.4.103 on A20-OLinuXino-MICRO-4GB with 4.3 TFT
All I had to do was run change_display.sh (its in /usr/bin folder)

Regards

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A20 => Topic started by: gatgat on March 22, 2016, 02:51:01 PM