I have installed the latest img of Debian using Win32diskimager and i used the ./change_display-noGUI.sh to set the LCD 7"
H: 480
W: 800
That's what i can see from the LCD :(.
https://drive.google.com/file/d/0BzzEnrqUXGfWY1Rka1I2dFZic2s/edit?usp=sharing
Any advise ?
Thx a lot in advance.
Some traces interesting:
[ 11.123603] [DISP] *** Timing:
<4>[DISP] *** lcd_x: 480
[ 11.129365] [DISP] *** lcd_x: 480
<4>[DISP] *** lcd_y: 800
[ 11.135816] [DISP] *** lcd_y: 800
<4>[DISP] *** lcd_ht: 525
[ 11.142258] [DISP] *** lcd_ht: 525
<4>[DISP] *** lcd_hbp: 40
[ 11.148623] [DISP] *** lcd_hbp: 40
<4>[DISP] *** lcd_vt: 576
[ 11.154978] [DISP] *** lcd_vt: 576
<4>[DISP] *** lcd_vbp: 8
[ 11.161258] [DISP] *** lcd_vbp: 8
<4>[DISP] *** lcd_hspw: 0
[ 11.167364] [DISP] *** lcd_hspw: 0
<4>[DISP] *** lcd_vspw: 0
[ 11.173459] [DISP] *** lcd_vspw: 0
<4>[DISP] *** lcd_frame_frq: 59Hz
[ 11.180182] [DISP] *** lcd_frame_frq: 59Hz
<4>[DISP] ***
[ 11.185681] [DISP] ***
<4>[DISP] *** Err04: Violate "(lcd_vt/2) >= (lcd_vbp+lcd_y+2)"
[ 11.193599] [DISP] *** Err04: Violate "(lcd_vt/2) >= (lcd_vbp+lcd_y+2)"
<4>[DISP] ***
[ 11.201534] [DISP] ***
<4>[DISP] *** Try new parameters, you can make it pass!
[ 13.217895] [DISP] *** Try new parameters, you can make it pass!
<4>[DISP] *** LCD Panel Parameter Check End
[ 13.227859] [DISP] *** LCD Panel Parameter Check End
<4>[DISP] *****************************************************************
[ 13.239506] [DISP] *****************************************************************
<6>Console: switching to colour frame buffer device 60x50
Ok, i had to run the script from the board itself and not from the ./change_display-noGUI.sh via UART. Now, i got the command prompt on the LCD but xorg crash:
I get this:
Parse error on line 1 of section InputClass in file /usr/share/X11/xorg.conf.d/20-ts.conf
I dont have any touch screen. Could it be the problem ?