Hello,
I run into some problems to boot up my board, i have tried to install the last official version of android on the nand and i have this error: (from UART)
__________
: ......6........ FES:INFO : ......7........ FES:INFO : ......8........ FES:INFO : ......9........ FES:CONFIG_USB_GADGET_DUALSPEED FES:fes connect to host FES:USB_MOV_DATA_BY_DMA! FES:INFO : ......10....... FES:jump to fes_main FES:INFO: fes_protocol_process start FES:[info]: set address 6 [FES]Err:ERROR : not support now ,get string descriptor,index = 238 FES:write special pipe FES:INFO: fed reg_addr = 0x40184688 FES:fed para[0] = 0x40a00000 FES:fed para[1] = 0x40a01000 FES:fed para[2] = 0x00000000 FES:fed para[3] = 0x00000000 [Fed]:-------------------------------------------------
[Fed]: Hello, SDCARD Register.
[Fed]:-------------------------------------------------
[mmc]: cmd 8 timeout, err 0x00000100
[mmc]: mmc cmd 8 err 0x00000100
[mmc]: cmd 55 timeout, err 0x00000100
[mmc]: mmc cmd 55 err 0x00000100
[mmc]: cmd 1 timeout, err 0x00000100
[mmc]: mmc cmd 1 err 0x00000100
[Fed]:Fail to physical init sdmmc.
[Fed]:-------------------------------------------------
[Fed]: Byebye, SDCARD Register.
[Fed]:-------------------------------------------------
FES:INFO : run addr = 0x00000000 , type = 1437204482
_______________
Is the board down ?
I saw this error with the SD card when trying to flash an image to it. I had to set the eraseflag in the sys_config.fex file.
You said you have the OS on NAND so if you have and SD card plugged it, remove it and see if the board boots.
The board seem's to boot on SD. (Linux) (No lcd, i will post on another thread...)
I tried to flash the nand without any card inserted with phoenix suit.
Just to be sure ...
Are you sure you downloaded the Android image for NAND and not the one for SDCard?
Quote from: Lurch on February 14, 2014, 03:00:13 PM
Just to be sure ...
Are you sure you downloaded the Android image for NAND and not the one for SDCard?
:-[