Hello,
I buy MOD-IO last week, and work with inputs, outputs, analog everything work's ok. (work alone)
Now I need to connect to other device via RS-232 (using mod-rsr232). They are any sample?
Thanks.
Hey paulovas,
The newer firmware (that your board probably has) uses I2C interface to communicate - in this case MOD-RS232 would not help you.
The older firmware used RS232 communication. You might find it here: https://www.olimex.com/Products/Modules/IO/MOD-IO/resources/MOD-IO-UART_Commands.zip (https://www.olimex.com/Products/Modules/IO/MOD-IO/resources/MOD-IO-UART_Commands.zip). Unfortunately it is no longer uploaded to MOD-IO boards and you would need an AVR programmer to load it to the MOD-IO.
We don't have any examples for MOD-RS232 since it is a very simple board - gets the TX and RX from the UEXT, puts them through a MAX3232CDR and outputs them on DB9 connector.
Best regards,
Lub/OLIMEX