Hi,
I use MOD-LCD4.3'' (new variant) board with default/example sw. I'm trying to see information via terminal of PC
via UART2USB cable (I have for a long time & use with other projects). When I connect 3 cable to UART2USB I see junk on the terminal (configured terminal correctly, with 115200 etc settings). Could you please check & give more information (picture) how & which pins to connect it. I also tried with MOD-RS232 with out success as well. So could you please help?
Below the instructions from readme file:
0) USB serial cables in the respective UEXT pins as follow:
2-GND (blue wire); 3-TX (green wire); 4-RX (red wire).
UART must be configured:
BaudRate: 115200
DataBits: 8
StopBits: 1
Parity: None
Thanks,Boris
Hi guys,
Could some one answer?
Thanks,
Boris