Hello
I have a PCD LCD 3310 and MOD-GPS unit. Until recently all was well. Then the GPS unit stopped sending its data. I read in this forum that yuribit put together a solution to get the voltage to his GPS up to 3.3 V. I have measured the supply voltage (from a mains powered unit) as 3.3 V. The voltage on pin 1 to UEXT is 2.99 to 3.00 V.
I don't think that I have a current supply issue. Is the solution to this problem to connect a wire between the ICSP pin 1 and the UEXT pin 1? I am uncertain about doing this as there maybe a problem on the board that I dont immediately see.
Suggestions are most welcomed.
regards