Print Page - olinuxino a13 with shields?

Title: olinuxino a13 with shields?
Post by: ellecieffe on April 12, 2013, 03:41:57 PM

Hi all
where Can I found some examples about the use of olinuxino with shields?

thnaks

Title: Re: olinuxino a13 with shields?
Post by: LubOlimex on April 16, 2013, 04:29:43 PM

Shields were meant to work with OLIMEXINO boards (e.g. Arduino and Arduino-like boards). It is possible to make them work on a breadboard of course since most shields use a standard communication protocol (I2C, SPI or UART) but we feel that this is are side projects that users can accomplish and design themselves.

The boards meant for extending the OLinuXino boards (and all boards with UEXT connector) are the ones with MOD- prefix and are usually listed here under different sub-categories: https://www.olimex.com/Products/Modules/ (https://www.olimex.com/Products/Modules/)

Best regards,
Lub/OLIMEX

Title: Re: olinuxino a13 with shields?
Post by: ellecieffe on April 16, 2013, 08:25:12 PM

I've understood. Thanks

Best Regards

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A13 => Topic started by: ellecieffe on April 12, 2013, 03:41:57 PM