Hi,
I am a electronic design engineer in USA. We have put out a product using an add-0n usb board with a 4.3 inch tablet to read barcoded cards. For our next version, the A20 looks to be very good. I would like to take the A20 dev board schematic you publish, make changes, and then have the board produced.
Do you provide design service (at some cost, of course :-) ) or do you focus on providing the variety of development boards?
Thanks,
Robert Ayers
robert.ayers@corecashless.com
913 226 2993 (usa)
sure we do, but public forum is not the place to discuss this :) please use info@olimex.com to send your requirements