Hello All
I've been playing around with the olinuxino maxi board and have been trying for a few days now to get the mcp2515 to play nice with my board. I learned about the device tree as I am a bit new at modifying device/board level kernel paramters.. I understand the concept but still seem to be missing some key low level paramters.
Anyways, here goes...
I have the following electrical connections:
1) CS tied to UEXT_CS
2) SCK tied to SSP2_SCK
3) SI tied to SSP2_MOSI Flying Together (https://www.flyingtogether.me/)
4) SO tied to PIN9/LCD_D08/SSP2_MISO
5) INT tied to AUART1_TXD
I am guessing that I have the wrong gpio setting or something like that, or maybe I do not have a complete dts definition for the mcp2515 part to work... any guidance would be greatly appreciated!
Thanks!
Which dts are you using?
I doubt you have INT right, BTW.
John
Hi,
Did you solve the issue? I'm getting this in dmesg:
mcp251x: probe of spi1.1 failed with error -2
Power is provided from the 3.3V rail. Should I upload the dts file here?