Print Page - SHIELD-EKG-EMG process in audrino

Title: SHIELD-EKG-EMG process in audrino
Post by: seewan on March 25, 2013, 02:45:34 PM

Hi

I want to do a project in which I will read the value from the shield and process the value and use it to control some device all in my ardunio . Is there any documentation on which pin to read etc ? do I need to create some sort of a filter for the signal .

Whats the D4 or D9 used for ? and the CAL_SIG . Any in depth documentation . I cannot find any in the user manual

thanks

Title: Re: SHIELD-EKG-EMG process in audrino
Post by: Mostafa on May 14, 2013, 02:51:40 PM

Quote from: seewan on March 25, 2013, 02:45:34 PM
I want to do a project in which I will read the value from the shield and process the value and use it to control some device all in my ardunio . Is there any documentation on which pin to read etc ? do I need to create some sort of a filter for the signal .

Whats the D4 or D9 used for ? and the CAL_SIG . Any in depth documentation . I cannot find any in the user manual

thanks

please i need to make the same thing , if you reach to any data please help me thanks

Olimex Support Forum

DUINO => SHIELDS => Topic started by: seewan on March 25, 2013, 02:45:34 PM