stuck on boot-up

[lucasbk]

I just purchased the A13-OLinuXino board with LCD and touchscreen.  I've used LiveSuit to update the firmware to sun5i_android_a13-evb_800x480_LCD_EN_SD.img.

Sorry, i fixed the paste...  Wrong part

I connected to UART1 to see what is going on.  I get to the following, and the board hangs after:
[    2.200000] device-mapper: multipath service-time: version 0.2.0 loaded
[ suspend: exit suspend, ret = -16 (1970-01-02 00:01:12.769392851 UTC)
[   91.650000] active wake lock unknown_wakeups, time left 500
ller using config : 0x1
[    2.220000] [mmc]: suing filesystems ... done.
[   96.670000] PM: Preparing system for mem sleep
er off !!
[    2.230000] [mmc]: mmc0 Probe: base:0xe08f2000 irq:32 dma:0 pdes:0xdf09c000, ret 0.
[    2.240000] usbcore: registered new interface driver usbhid
[    2.250000] usbhid: USB HID core driver
[    2.250000] logger: created 256K log 'log_main'
                                                                                                              [   96.740000] [sw-ohci1]: sw_ohci_hcd_suspend
[   96.740000] usb_passby en=0,passly=2
[   96.750000] hci_port_coger: created 256K loc 'log_system'
[    2.270000] enter sun5i Audio codec!!!
[    2.270000] sun5i audio support initialized
[    2.280000] sun5i Audio codec successfully loaded..
[    2.280000] ALSA device list:
[  .770000] usb_passby en=0,passly=1
[   96.770000] [sw-ehci1]: close clock
[   96.780000] [audio codec]:suspend start
ntrack version 0.5.0 (5664 buckets, 22656 max)
[    2.300000] ctnetlink v0.93: registering with nfnetlink.   



Thanks in advance.

[olimex]

android image have power safe mode, if you do not touch anything for a while it goes to power down mode as any normal tablet to save it's battery

[lucasbk]

I reverted back to the VGA firmware and it works well. 
I've reprogrammed the image with LCD support and it boots but I'm not seeing anything on the display.
The backlight turns on then back off again.
I have a shell via the UART and I can see what processes are running, etc.
Anyone else have something similar happen to them?
 

[lucasbk]

found the problem, the lcd connector's clip was loose enough to cause a bad connection!  After re-seating it all is well...  Doh!