Hello,
I have a problem that the Electricguru unable to show correct ECG waveform. It only show a very small signal in between the amplitude -100 to 100 and looks like a noise. The port is chosen correctly and the arduino UNO are working fine. So what is the problem with Electricguru or any setting?
Now I am using Arduino UNO and Olimex EKG-EMG shield as well as its PA.
Please help me to solve this problem. Thank you in advance
i have a same problem, i need help whit this, because i doing all explianed in te manual but donĀ“t run good in the electricguru program. where is the problem?
thanks for readme.
Javi