Hi,
i have a Lime2
when i flash rom to it first time it boots without problem, but when i shut down properly and reset
i get
"EXT4-fs error (device nande): ext4_lookup:1050: inode #2: comm zygote: deleted inode referenced: 16" error and then I/O errors like
"Could not stat dex cache directory '/data/dalvik-cache': I/O error".
and it stays in loop at android logo. is this a software issue, how could i fix this. after reflash it boots once without problem again then loop again
i am using olinuxino-a20.tgz .
Regards
Alli
Hi,
when i flash this official android image to lime2
https://www.olimex.com/wiki/A20-OLinuXino-LIME2#Android
it also does not boot
log is like this
is something wrong with board ?
Regards
[ 0.486] battery enough
[ 0.487] power_start=0x00000000
[ 0.487] pre sys mode
[ 0.490] key value = 0
[ 0.492] recovery key high 40, low 4
[ 0.514] show pic finish
[ 0.514] load kernel start
[ 0.533] load kernel successed
[ 0.533] start address = 0x4a000000
[ 1.030] power exit detect
[ 1.030] usb exit detect
[ 1.030] jump to
[ 1.033] set retry default value: [ 1.036] 0x00000020[ 1.038] 0x00000020[ 1.040] 0x00000072[ 1.043] 0x000000bf[ 1
U-Boot 2011.09-rc1-00000-geceb6aa-dirty (May 06 2014 - 12:52:25) Allwinner Technology
CPU: SUNXNB1 : init ok
3480 MiB
In: serial
Out: serial
Err: serial
--------fastboot partitions--------
-total partitions:11-
-name- -start- -size-
bootloader : 8000 8000
env : 10000 8000
boot : 18000 8000
system : 20000 140000
data : 160000 100000
misc : 260000 8000
recovery : 268000 10000
cache : 278000 140000
databk : 3b8000 80000
private : 438000 8000
UDISK : 440000 28c000
-----------------------------------
bootcmd set setargs_nand
Hit any key to stop autoboot: 0
set retry default value: 20 20 72 bf
[NAND]dumy read,chip 0
Starting kernel ...
[ 0.772284] something wrong in chip id
[ 1.455917] something wrong in chip id
[ 1.460452] something wrong in chip id
[ 1.469560] something wrong in chip id
[ 2.652513] init: width = 800
[ 2.655840] init: height = 480
[ 2.659281] init: s.st_size = 1536000
[ 2.693584] EX[ 2.740379] init: buffer : /dev/block/nande
[ 4.194871] init: do_umount: /data
[ 4.198800] init: do_umount error = Invalid argument
[ 4.376600] EX[ 4.420313] init: buffer : /dev/block/nandh
[ 6.125179] init: do_umount: /cache
[ 6.129232] init: do_umount error = Invalid argument
[ 6.181092] init: start format /dev/block/UDISK
[ 6.186398] init: wait for format /dev/block/UDISK
[ 6.186617] init: fork to format /dev/block/UDISK
[ 7.726837] init: format /dev/block/UDISK ok
[ 7.734001] EX[ 7.790334] init: buffer : /dev/block/nandi
[ 8.637451] init: do_umount: /databk
[ 8.641604] init: do_umount error = Invalid argument
[ 8.679780] init: cannot find '/system/etc/install-recovery.sh', disabling 'flash_recovery'
[ 9.134257] something wrong in chip id
[ 11.692211] android_usb: already disabled
[ 11.696994] init: using deprecated syntax for specifying property 'sys.usb.config', use ${name} instead
[ 11.708907] init: using deprecated syntax for specifying property 'sys.usb.config', use ${name} instead
shell@android:/ $