September 27, 2021, 07:26:19 am

TMS570 CAN

Started by Martin, October 26, 2012, 02:06:46 pm

Previous topic - Next topic

Martin

Hi, I need the full pin out information for the breakout headers on this board, specifically, which are GND?
cheers,
Martin

LubOlimex

Hey Martin,

There is a new schematic available since the old one wasn't good enough (especially around the GPIO pins). Check it here: https://www.olimex.com/Products/ARM/TI/TMS570-CAN/resources/TMS570-CAN-SCHEMATIC-REV-A.pdf. Refresh it since it has the same name as the old one.

There is no GND nor POWER on the headers. This wasn't a design flaw it was intended. That's why we left GND, +3.3V and +5V near the CAN2 connector. Additionally there is a GND on the CAN2 connector (check the bottom print).

Regards,
Lub/OLIMEX
Technical support and documentation manager at Olimex