I just received the new Nano-board with BB and BAT additions. I am little rusty with hardware, so I have tried to read some information, but most texts are for Mega or Uno boards and I think Nano is more like Leonardo. So I wonder how to convert Arduino examples' settings for the new Nano board?
The nano board is really nice and I would like to use it with battery power, but I wonder if there is any help how to do it?
I wonder if there is plans to make a prototyping board with same dimension as the other cards as the BB-card "ruins" the nice figure.
You don't need to change the code. Just pick Leonardo as board. You may have to install a driver for the USB-RS232. You should use a wait if you want to use output. The examples show this for Leonardo.
void wait_for_input(void)
{
Serial.println("Wait for input!");
while(Serial.available() == 0);
while(Serial.available() != 0){ Serial.read(); };
}
void setup()
{
Serial.begin(9600);
while(!Serial); //wait for serial port to connect - needed for Leonardo only
wait_for_input();
Serial.println("GLCD go...");
...