Print Page - How to use Multiple ARM USB JATG programmers on one PC at a time

Title: How to use Multiple ARM USB JATG programmers on one PC at a time
Post by: gadgilmv on April 07, 2015, 07:45:38 PM

I have a use case where i need to connect multiple ARM USB JTAG to single computer & use them to programm multiple boards at a time. Can you suggest if we can do it with the device that we are using.
does it allow to change VID, PID run time to make this task easier

Title: Re: How to use Multiple ARM USB JATG programmers on one PC at a time
Post by: freeck on April 18, 2015, 11:20:06 PM

See https://www.olimex.com/Products/ARM/JTAG/_resources/ARM-USB-OCD_and_OCD_H_manual.pdf

Olimex Support Forum

ARM => JTAG => Topic started by: gadgilmv on April 07, 2015, 07:45:38 PM