########################################################################
#
#                           GettingStarted.eww
#
#
########################################################################

DESCRIPTION
===========
 This example project should be used only with IAR Embedded Workbench for ARM

 It shows basic use of I/O,	timer and the interrupt controllers.
 It starts by blinking USB Link LED.

COMPATIBILITY
=============

   The example project is compatible with Olimex-LPC-P2378 evaluation 
  board. By default, the project is configured to use the J-Link JTAG 
  interface.

CONFIGURATION
=============

   After power-up the controller get clock from internal RC oscillator that
  is unstable and may fail with J-Link auto detect, therefore adaptive clocking
  should always be used. The adaptive clock can be select from menu:
  Project->Options..., section Debugger->J-Link/J-Trace  JTAG Speed - Adaptive.

   Make sure that the following jumpers are correctly configured
  
  PWR_SEL     - depending of power source
  USBC/USBSC  - USBSC
  RST_E       - unfilled
  ISP_E       - unfilled

GETTING STARTED
===============

  1) Start the IAR Embedded Workbench for ARM.

  2) Select File->Open->Workspace...
     Open GettingStarted.eww workspace:

  3) Run the program.
