Step by step instruction for OLIMEX LPC-P2378(Rev. A) board programming.

1. Download and Install flash magic software: http://www.esacademy.com/
2. Start Flash Magic. Select following settings:   COM port:COM1 or the your free COM port
                                                                       baud rate:9600
                                                                       Device:LPC2378
                                                                       Interface: None(ICSP)
                                                                       Oscilator: 12.000MHz
3. From PWR_SEL jumpers choose 1-2 position, i.e. external power source 9V
4. Close ISP_E and RST_E jumpers. 
5. Connect straight RS232 cable from your PC to RS232_0(DB9-female) connector on the board.
6. Plug in power supply and Erase the device.       
7. Load attached LED_BLINK.HEX
8. Start programming with START button.
9 . Remove ISP_E and RST_E jumpers and press RST button. USB_LINK led on the board have to blink. 