INTRODUCTION:

ARDUINO like board with PIC32MX440F256H with USB OTG

FEATURES:

• PIC32MX440F256H 80 Mhz microcontroller 256KB Flash 32KB RAM
• microSD card for data logging
• UEXT connector which allow many existing modules like RF, ZIGBEE, GSM, GPS to be connected
• two LEDs
• one BUTTONs
• RESET button
• mini USB connector is used which is common and used in most cell phones, so you do not have to buy other cables
• all PIC ports available on 0.1" connectors
• miniICSP connector 0.05"step if you do not want to use Pinguino IDE and want to program this board with PIC-ICD2-POCKET or PIC-KIT3 you should use also PIC-ICSP convertor board, same apply for Microchip programmers.

DOCUMENTS:

• PIC32-PINGUINO-MICRO - User manual

HARDWARE:

• PIC32-PINGUINO-MICRO schematic in PDF format
• PIC32-PINGUINO-MICRO schematic in Eagle format released under Creative Commons Attribution-Share Alike 3.0 United States License
• PIC32-PINGUINO-MICRO board in Eagle format released under Creative Commons Attribution-Share Alike 3.0 United States License

WARNING:

Do not use "programmer-to-go" button when there is no image on the OLIMEX PIC-KIT3 or MICROCHIP PIC-KIT3 or that might put your microcontroller in an inrecoverable state. We have tested the mentioned scenario and we can confirm it destroys PIC32 chips (using both our and the original Microchip PICKIT3). We don't take responsibility if you brick your chip that way. For more info check the following: www.microchip.com/forums/m635420.aspx.

SOFTWARE:

• PINGUINO IDE INSTALLATION on Windows
• PINGUINO IDE Linux installation script

ORDERING CODES:
		PIC32-PINGUINO-MICRO completely assembled and tested