PIC-PG3 - PARALLEL PORT PIC 8/18/28/40 PIN DEVICES PROGRAMMER

FEATURES:

• PIC-PG3 is programmer based on D.Tait's parallel port design. To operate it needs external power supply 12-15VAC or 16-18VDC. It supports all 8/18/28 and 40 pin PIC microcontrollers which allow serial programming. PIC-PG3 have connector and cable for ICSP programming and can be used to program all PIC-PxxB prototype boards.
• The supported devices depend on the current version of ICPROG software.
• Dimensions 75x58 mm (3x2.3") + 30 cm (12") ICSP cable

DOCUMENTS:

• PIC-PG3.pdf - Users Manual
• PIC-PG3 tutorial by our US reseller SparkFun
• Sparkfun's PIC-PG3 tutorial in Spanish translated by our South American reseller Ingeneria MCI
• NOTE: The programmer may not work with low power serial interfaces - i.e. laptop or notebook serial ports. USB to serial cables have also not been proven to work.

HARDWARE:

• PIC-PG3 schematic
• PIC ICSP connector

• ICPROG from Bonny Gijzen freeware for programming many PICs, sometimes it doesn't work on some computers read here why.
• PICPgm freeware PIC programming software by Christian Stadler supports many PICs and is officially supporting our PIC-PG1/2 and PIC-PG3
• PICALLW - SHAREWARE software by Bojan Dobaj
• FREE software by Nigel Goodwin
  

FAQ:

Q: My computer have no LPT port. Can I use USB to LPT converter with PIC-P3?
A: No, the USB to LPT converters add delay due to USB nature and this will mess up the programming timing. If you want USB programmer consider PIC-ICD2-POCKET.

ORDERING CODES:
		PIC-PG3 Fully assembled and tested