PIC-PG2 - SERIAL PORT PROGRAMMER FOR 8/18/28/40
PIN PIC MICROCONTROLLERS AND I2C EEPROMS + ICSP connector and cable



FEATURES:
- PIC-PG2 is programmer based on JDM
design which takes all necessary signals and power supply from RS232 serial
port. It supports 8, 18, 28 and 40 pin PIC microcontrollers which allow serial
programming and I2C EEPROM memories. Programmer comes with ICSP cable for
direct connection to PIC-Pxx prototype boards.
- The supported devices depend on the current version of ICPROG software.
- Dimensions 50x30 mm (1.95x1.2") + 30 cm (12") ICSP cable
DOCUMENTS:
- PIC-PG2.pdf - Users manual
- PIC-PG2
tutorial by our US reseller SparkFun
- Sparkfun's PIC-PG2
tutorial in Spanish translated by our South American reseller Ingeneria
MCI
- NOTE: The programmer may not work with low power serial interfaces - i.e.
laptop or notebook serial ports. USB to serial cables have also not been proven
to work.
HARDWARE:
SOFTWARE:
- ICPROG from Bonny Gijzen
freeware for programming many PICs, sometimes it doesn't work on some computers
read
here why.
- PICPgm
freeware PIC programming software by Christian Stadler supports many PICs
and is officially supporting our PIC-PG1/2 and PIC-PG3
- WinPIC - Great
new software by Wolfgang "Wolf" Bnscher. Supports all the popular
flash PICs, as well as many of the newly released PICs! Use this software
for support for the 16F628A, 16F87, and 16F88.
FAQ:
Q: My computer have no RS232. Can I use
USB to RS232 converter with PIC-PG2?
A: No, the USB to RS232 converters add delay due to USB nature and this will
mess up the programming timing. If you want USB programmer consider PIC-ICD2-POCKET.
ORDERING CODES:
PIC-PG2 Fully assembled and tested
Click here for our PRICELIST and shipping
options, and click here to learn HOW
TO ORDER