LPC-P2919 DEVELOPMENT PROTOTYPE BOARD WITH LPC2919 2x CAN, 2x LIN , SD/MMC

FEATURES:

• MCU: LPC2919 ARM968E-S, 125 MHz, CAN, LIN, 56 kB SRAM, 768 kB flash, x2 10-bit ADCs
• JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG, ARM-USB-OCD, ARM-USB-TINY
• RS232 port
• two CAN drivers and connectors
• two LIN drivers and connectors
• LCD 8X1
• SD/MMC card connector
• two user buttons
• trimpot connected to ADC
• RESET circuit and button
• three status LEDs
• power supply LED
• jumper for Power Selection mode
• three on board voltage regulators 1.8V, 3.3V and 5V with up to 800mA current
• single power supply: External power supply +9VDC required, or takes power from JTAG connector
• 16 Mhz crystal oscillator
• UEXT connector with SPI, RS232 and power supply for connecting add-on modules
• Extension port connector for many of microcontrollers pins
• Prototype area
• PCB: FR-4, 1.5 mm (0,062"), red soldermask, silkscreen component print
• Dimensions: 140x89mm (5.512x3.504")

DOCUMENTS:

• LPC-P2919 users manual

• LPC-P2919 schematic

• LPC-P2919 buttons and LCD example demo code for EW-ARM 5.40
• LPC-P2919 potentiometer, UART, LCD example demo code for EW-ARM 5.40
• LPC-P2919 SD-MMC card example demo code for EW-ARM 5.40
• LPC-P2919 CAN message exchange example demo code for EW-ARM 5.40 (in development)
• LPC-P2919 LIN message exchange example demo code for EW-ARM 5.40 (in development)
• LPC-P2919 CAN to RS232 message bridge example demo code for EW-ARM 5.40 (in development)

ORDERING CODES:
		LPC-P2919 - assembled and tested board, includes LPC2919 microcontroller